Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (September 2006, week 3)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Fri, 15 Sep 2006 11:23:57 -0400
Reply-To:     neil <goofymuso@YAHOO.CA>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         neil <goofymuso@YAHOO.CA>
Subject:      Re: Pilot bearing grease type
Comments: To: Shawn Wright <vwdiesels@GMAIL.COM>
In-Reply-To:  <450A5627.23747.9E6FFF50@vwdiesels.gmail.com>
Content-Type: text/plain; charset=iso-8859-1

Hi.

Although I did look at old bearing, I'll double check the, ahem, "marks" I made delicately removing it. I just can't go on a blind faith that things were installed correctly to start with. i.e. this van had 2 (!) new clutches installed in a short length of time. The last work order showing that something had gone really wrong with previous clutch. Dont' know if a new pilot bearing was installed in 2nd clutch job.

Thanks,

Neil.

--- Shawn Wright <vwdiesels@GMAIL.COM> wrote:

> I've always used Moly grease, same stuff I use on > CVs. I use it anywhere heat is an issue. I > don't recall a big difference between each end of > the needle bearing, but I don't have a loose > one to check. I would think if one end of the case > has a larger inside diameter, then this > should face the clutch. The beefier end going toward > the crank, making it easier to remove > the old one... but I could be wrong. ;-\ > > On 14 Sep 2006 at 23:25, neil <goofymuso@YAHOO.CA> > wrote: > > > ok. so what exactly is > > > > "bosch grease" ? > > > > And which end of needle bearing goes into hole of > > flywheel? > > > > > > > > Please and thanks, > > > > Neil. > > > > > > --- Aaron <lists@MYCOMMUNITYNET.NET> wrote: > > > > > > Wheel bearing grease will get hot and then fly > out > > > onto your clutch > > > > disc. > > > > Bosch grease won't do this. > > > > > > I can attest to this...although it wasn't wheel > > > bearing grease, it > > > was not the right grease, and not I get to pull > the > > > tranny again. Use > > > the right stuff and be done with it. > > > > > > > > > __________________________________________________ > > Do You Yahoo!? > > Tired of spam? Yahoo! Mail has the best spam > protection around > > http://mail.yahoo.com > > > Shawn Wright > http://members.shaw.ca/vwdiesels > '88 Westy 1.6TD 5 speed > '85 Jetta Diesel 1.6NA >

__________________________________________________ Do You Yahoo!? Tired of spam? Yahoo! Mail has the best spam protection around http://mail.yahoo.com


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.