I had that same problem. Check to make sure you have the OEM pump. In my case the PO put in another pump which was too powerful. I replaced it with an OEM pump and the pressure is just about right now. Pascal "84 Westy -----Original Message----- From: Vanagon Mailing List [mailto:vanagon@gerry.vanagon.com] On Behalf Of John Graham Sent: September 25, 2006 1:56 PM To: vanagon@GERRY.VANAGON.COM Subject: High sink water pressure
One of the things that I wish I could change is the rate at which water spews out of the sink faucet just on the pressure from the little pump in the water tank. It splatters all over if you're not filling a pot or some container. I understand that this is a function of little faucet opening and the pump pressure. Has anyone modified their sink faucets is someway to lessen this? John Graham 88 Westy Charlotte, NC |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.