Date:         Tue, 26 Sep 2006 08:42:14 -0300
Reply-To:     "Giasson, Pascal (DNR/MRN)" <Pascal.Giasson@GNB.CA>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         "Giasson, Pascal (DNR/MRN)" <Pascal.Giasson@GNB.CA>
Subject:      Re: High sink water pressure
Comments: To: John Graham <theklube@GMAIL.COM>
In-Reply-To:  A<194423170609250955l5facaa0fn9d6a1565830a5211@mail.gmail.com>
Content-Type: text/plain; charset="us-ascii"

I had that same problem.  Check to make sure you have the OEM pump.  In
my case the PO put in another pump which was too powerful.  I replaced
it with an OEM pump and the pressure is just about right now.

Pascal
"84 Westy

-----Original Message-----
From: Vanagon Mailing List [mailto:vanagon@gerry.vanagon.com] On Behalf
Of John Graham
Sent: September 25, 2006 1:56 PM
To: vanagon@GERRY.VANAGON.COM
Subject: High sink water pressure


One of the things that I wish I could change is the rate at which water
spews out of the sink faucet just on the pressure from the little pump
in
the water tank.  It splatters all over if you're not filling a pot or
some
container.  I understand that this is a function of little faucet
opening
and the pump pressure.  Has anyone modified their sink faucets is
someway to
lessen this?

John Graham
88 Westy
Charlotte, NC