Vanagon EuroVan
Previous (more recent) messageNext (less recent) messagePrevious (more recent) in topicNext (less recent) in topicPrevious (more recent) by same authorNext (less recent) by same authorPrevious page (October 2006, week 1)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Sat, 7 Oct 2006 10:57:16 -0400
Reply-To:     Mike Collum <collum@VERIZON.NET>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Mike Collum <collum@VERIZON.NET>
Subject:      Re: 1.9 WBX cooling system repair
Comments: To: George Thorburn <thorgk@ACCESSCOMM.CA>
In-Reply-To:  <000f01c6ea1d$7cf41540$6e00a8c0@owner998c7c609>
Content-type: text/plain; charset=ISO-8859-1; format=flowed

On my '84, when that nipple broke off, I trimmed the support web under where the nipple was then got a piece of brass tubing and heated it so that it would melt its way into the hole (with the help of pliers, of course). Just for the sake of overkill, I then put J-B Weld around the joint. I used it that way for 4 years, which included a number of long trips. I replaced it with a new one "Just Because" (obtained from a list member ... either Vanagain or BusDepot ... don't remember) and still have the repaired one as a spare.

Actually, in an emergency, one could trim that support web from under where the nipple broke off and fit a hose over the now accessible nub.

Mike '84 GL 7 pass '85 GL Westy

George Thorburn wrote: > Hey list, > Some time ago the nipple on the assembly mounted to the front of the engine compartment broke off. (the assembly with the bleed screw where the large hoses come together and a small diameter bleed hose goes back toward the back of the motor) The broken nipple was repaired with a short length of 1/4" steel tubing threaded into the plastic assembly. This is OK but I was wondering if any one had a better idea. Is the large plastic assembly still available? Is there a repair kit available some where? What I would like is a metal tube that would thread in and would have barbs or a bulge to help hold the small rubber hose in place. > Any ideas would be appreciated. > Thanks, > George > '85 Westfalia >


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.