Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (October 2006, week 1)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Sat, 7 Oct 2006 15:57:00 -0600
Reply-To:     George Thorburn <thorgk@ACCESSCOMM.CA>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         George Thorburn <thorgk@ACCESSCOMM.CA>
Subject:      Re: 1.9 WBX cooling system repair
Comments: To: jfarrugi@UMICH.EDU
Content-Type: text/plain; charset="iso-8859-1"

>>did either of you orifice your temporary pipes? if i remember correctly >>this nipple is not full diameter.

>>jonathan

I did not, but noticed that the inside diameter of the copper tube is smaller than the steel tube that the mechanic used. (about 5/32" for the steel compared to 1/8" for the copper - not exact measurements - I checked by trying drill bits until I found one that would fit in the tube) What is the inside diameter of the stock nipple?

George


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.