Date:         Sun, 1 Oct 2006 17:34:15 -0700
Reply-To:     Zoltan <zolo@FOXINTERNET.NET>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Zoltan <zolo@FOXINTERNET.NET>
Subject:      Re: front door edge seals wasRe: 88-up flow-through parts
Comments: To: JordanVw@AOL.COM
Content-type: text/plain; format=flowed; charset=iso-8859-1; reply-type=original

I may have missed this thread.
If you talk about the front door edge seal, that is between the body and the
front edge of the front door, sticking out a little, then that is what I can
tell about.
That seal is about two feet long and fits into a channel.  One can pull it
out from the top and install it back after painting with some wd40.
Patience required.
Zoltan
But if its something else you guys talking about, then I'm out of it.
----- Original Message -----
From: <JordanVw@AOL.COM>
To: <vanagon@GERRY.VANAGON.COM>
Sent: Sunday, October 01, 2006 11:16 AM
Subject: front door edge seals wasRe: 88-up flow-through parts


>> The front door edge seals are held in by two screws and one bolt on each
>> side. You will need to remove the door to get to them as the access hole
>> is
>> obstructed by the hinge.
>>
>>
>
> there are four small 8mm bolts that hold these on each side.   two are
> accessable thru the hinge bolt holes once the door is removed, the other
> two are
> not.   in fact the only way to remove the other 2 bolts is with a flex
> joint
> extension, as theyre hidden behind the lip of the front clip.  this is on
> a 90
> vanagon i have here with the door off..  maybe other years use a different
> amount
> of bolts.. not sure.   anyway i gave up removing them as i couldnt get at
> the
> heads for the other two bolts.
>
> chris
>
>
> --
> No virus found in this incoming message.
> Checked by AVG Free Edition.
> Version: 7.1.407 / Virus Database: 268.12.11/460 - Release Date:
> 2006.10.01.
>
>