Date: Tue, 17 Oct 2006 10:40:49 -0700
Reply-To: Zoltan <zolo@FOXINTERNET.NET>
Sender: Vanagon Mailing List <vanagon@gerry.vanagon.com>
From: Zoltan <zolo@FOXINTERNET.NET>
Subject: Re: Weekender interior questions
Content-type: text/plain; format=flowed; charset=iso-8859-1; reply-type=response
I did once this project. The whole interior had to be exchanged. And that
table bracket was quite a job to install. Then the removable seats' anchors
had to be welded in. And the floor's thick insutlation to make it the same
level. Drilling holes and weld nuts behind the removable seats.
The rear seats have to come from the donor too. The table lock almost never
works. You can use a magnet that Mr. Condelli sells. Keep the vinyl
covering on the body intact.
Zoltan
----- Original Message -----
From: "Mark Drillock" <mdrillock@COX.NET>
To: <vanagon@GERRY.VANAGON.COM>
Sent: Tuesday, October 17, 2006 10:16 AM
Subject: Re: Weekender interior questions
> The upper nuts are not welded to the body. They are attached to a
> separate upper bracket that is riveted in place up inside the van wall.
> It can be removed and mounted in another van. The upper bracket is about
> 3 feet long and attachers at each end with some pop-rivets. Drill out
> the rivets and pry it loose. It is specially shaped to precisely fit and
> locate itself.
>
> Mark
>
> roger sisler wrote:
>
>> Hello there. I will annoy you fine folks this one last time-this week. I
>> need to know about the weekender interior. My marketeer, Larry, say us
>> that weekenders dont really exist. I have found one and am trying to
>> convince him that they do.He is on vacation ,right now, and I may have
>> sell it before he returns. His loss.
>>
>> Specifically, can this wall panel that holds the table be retrofitted
>> into a 1987 syncro that did not origionally come with the special
>> interior? The particular issue is the upper table mounting bolt fastner
>> nuts that are welded into the vanagon at the factory and painted along
>> with the exterior and interior steel.They are way up inside the window
>> channel area,and would be very difficult to retrofit,themselves.The table
>> mount bolts to these holes at the top, and I think the table mount is pop
>> rivited to the bottom. Can a weekender set up be retrofitted without
>> needing to add these imposiable to get at nuts? Are the nuts included
>> with all vanagons regardless whether or not they have the weekender
>> interior? Thanks,Roger
>>
>>
>> ---------------------------------
>> Get your email and more, right on the new Yahoo.com
>>
>
>
> --
> No virus found in this incoming message.
> Checked by AVG Free Edition.
> Version: 7.1.408 / Virus Database: 268.13.4/476 - Release Date:
> 2006.10.14.
>
>
|