To use POR seam sealer, best to prep the seams,first.Gouge,and sand out all calk and look at the inside.Probably some rust is showing. Use POR 15 marine clean and metal ready for best adheasion. I would use a spray gun w/air compressor, to force the marine clean and metal ready into the seam. From both sides. Then use the sealer.Finally ,just gotto cross your fingers. |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.