Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (November 2006, week 1)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Wed, 1 Nov 2006 11:12:13 -0500
Reply-To:     Jake Beaulieu <jbeaulie@ND.EDU>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Jake Beaulieu <jbeaulie@ND.EDU>
Subject:      GoWesty extra battery wiring kit

Howdy,

I picked up the Go Westy wiring kit for an auxillary battery in my 1982 air cooled westy. I have been comparing the instructions that came with the kit to several informative posts in the archives. First, for anybody interested in learning more about this subject I reccomend reviewing the following three posts:

Post 1: Date: Fri, 29 Jan 1999 10:49:32 -0800 Sender: harald_nancy <harald_nancy@EARTHLINK.NET> Subject: Re: Flash Alert! Dual Battery Relay Post 2: Date: Sun, 31 Jan 1999 12:41:51 -0800 Sender: harald_nancy <harald_nancy@EARTHLINK.NET> Subject: Dual Battery Relay - Part 2 (long) Post 3: Date: Wed, 10 Mar 1999 17:27:26 -0800 Sender: Davidson <wdavidson@THEGRID.NET> Subject: Auxiliary Battery Madness (looong)

Ok, so the Go Westy kit comes with a solenoid that runs between the starter and auxilllary battery. The instruction recomends running a wire from one side of the solenoid to the bottom of fuse 8 (power from starter battery). The other side of the solenoid runs to the positive terminal of the auxillary battery. This seems to contrast with the reccomendation of the above posts to connect one side of the solenoid directly to the positive terminal of the auxillary battery and the other side directly to the positive terminal of the starter battery. I guess the rational is that there is a voltage loss between the starter battery and the fuse panel and that this will reduce how much the auxillary battery can get charged. Any ideas on why Go Westy reccomends tapping into fuse 8 rather than directly to the starter battery?

My second question regards the trigger wire for the solenoid. Go Westy suggests tapping into a blue wire that can be found running behind the fuse panel for the trigger circuit. They don't identify this wire, but I believe it comes from the alternator. The posts I referenced above suggest tapping into the trigger wire circuit already wired to the fridge relay under the drivers seat. I suppose both methods work as long as they only trigger the solenoid when the van is running (and NOT while the starter in engaged). Any thoughts the relative merits of these two different trigger circutis.

I love this listserve, Jake


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.