Axually the 1.9L and 2.1L wear very little on the rings, cyl,. and pistons. Almost all the engines I rebuild this year have shown mill marks still on the cyl walls. Not a single one of these engine had less than 100,000 miles on them.
Don Deitke wrote: >It is stated that you put all new parts etc. into your rebuild which sounds >very good . The thing that I do not see is NEW pistons & cylinders to match >the new rings ?? Horizontal engines wear the pistons and cylinders and rings >egg shaped >You do not put new round rings into 2 worn egg shaped objects // doing so >can cause compression loss or overheating OR BOTH in the piston / cylinder >area. > >Don @ DVW _www.dvwimportautoparts.com_ >(http://www.dvwimportautoparts.com) > > > |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.