Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (November 2006, week 3)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Tue, 21 Nov 2006 05:36:50 -0800
Reply-To:     Malcolm Stebbins <mwstebbins@YAHOO.COM>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Malcolm Stebbins <mwstebbins@YAHOO.COM>
Subject:      How do we remove ignition key assembly..?
Content-Type: text/plain; charset=iso-8859-1

I searched and searched and I came up with several good posts (see below) but I'm not sure WHERE to drill the hole to release the 'retaining spring'.

Who has a paint package (PhotoShop-ish) so I can send some digi-photos and, you can be so nice as to circle exactly WHERE to drill the hole and how big a drill bit to use. Thanks Malcolm (Halifax)

> Date: Tue, 12 Sep 2006 23:36:37 EDT > From: Jeff Oxroad <Oxroad@AOL.COM> > Subject: Re: How do we remove key assembly..? > To: vanagon@GERRY.VANAGON.COM > > Basically you have to drill a release hole and poke the retaining spring out > of the way. If you don;t have Bentley then repost and I'll get into more > detail.

> Date: Sun, 29 Oct 2006 18:28:15 -0800 > From: jon <jon@KENNEKE.COM> > Subject: My Ignition switch replacement experience > To: vanagon@GERRY.VANAGON.COM > > It was a pleasant job. It took about 45 minutes (not counting a trip to > the FLAPS to get a 24mm socket). > > 1) Remove shaft "cowling" > 2) Remove horn plastic assembly (just pulls off) > 3) Remove 24mm bolt > 4) Pull steering wheel off (no puller required) > 5) Remove 3 screws around the stem assembly > 6) Remove stem (wiper, turn signal sw,itches) assembly > 7) With pliers, remove the plastic collar around shaft > 8) Remove all 3 (or is it 4) wire connectors > 9) Remove hex nut holding switch/lock assembly > 10) Remove switch/lock assembly (with key "on") > 11) Remove switch assembly (there is a screw inside holding it to the > lock) > 12) Install new switch assembly > > And, as Bentley says: Reverse for installation.

____________________________________________________________________________________ Sponsored Link

Mortgage rates near 39yr lows. $510k for $1,698/mo. Calculate new payment! www.LowerMyBills.com/lre


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.