In a message dated 12/2/06 6:35:22 PM Eastern Standard Time, rogersisler2000@YAHOO.COM writes:
> I have two power mirrors that are dissasembled.I cannot get the little nut > on the shaft where the spring is. Now matter how much I press on the nut,I > cannot compress the spring and make the nut spin and catch on the shaft.. How > did you do it? > hey POR-15 man! .. the way i put that nut in there is use a deep socket..or i have a piece of pipe i made into a tool for doing this.. you just have to catch the thread right..the same time your pressing down.. and be careful, or you'll crack the potmetal shaft...or mirror housing.. its easier to do with the wires out of the way..
chris |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.