Vanagon EuroVan
Previous (more recent) messageNext (less recent) messagePrevious (more recent) in topicNext (less recent) in topicPrevious (more recent) by same authorNext (less recent) by same authorPrevious page (December 2006, week 2)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:   Fri, 8 Dec 2006 14:50:21 -0500
Reply-To:   Greg Potts <greg@POTTSFAMILY.CA>
Sender:   Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:   Greg Potts <greg@POTTSFAMILY.CA>
Subject:   Re: Help removing stripped CV joint bolts
Comments:   To: chris <chris@MCCLURKEN.COM>
In-Reply-To:   <1165597166.10752.7.camel@chris-desktop>
Content-Type:   text/plain; charset=US-ASCII; delsp=yes; format=flowed

Hi Chris,

I ran into this problem with a vanagon I parted out a couple years ago.

Firstly, be sure to be using the correct tool for the CV bolts. On aircooled buses I have encountered both 12-point socket-headed bolts and allen-socket heads. Not sure which is correct but if you have the wrong tool they won't turn.

Firstly Spray the bolts with brake cleaner or some other solvent and use a fine pick or tool to clean out any crud in the sockets. Tap the tool in gently with a hammer. Sometimes if they won't loosen you get good results by trying to tighten them first. Not sure why, but it sometimes works for me.

If they are well and truly stripped then heat and vice grips will work OK on the transmission end of the CV. Tighten the vice grips up as tight as humanly possible and clamp them onto the bolts. If the bolts at the wheel end are stripped then you're in for a world of hurt, because vice grips are not going to reach into the cage where the CV is located. A $60 bolt extractor kit would be worthwhile for those. I gave up and cut the axle. (It was a parts van anyway).

Fresh bolts to replace the abused ones are worth the investment.

Happy Trails,

Greg Potts 1973/74/75/77/79 Westfakia "Bob the Tomato" www.pottsfamily.ca/westfakia www.busesofthecorn.com

On 8-Dec-06, at 11:59 AM, chris wrote:

> Anyone out there know of a tool for stuck/stripped/rounded out CV > Joint > bolt? I'm swapping the transmission on my 85 GL and I've found a > nightmare or stripped bolts. The outside of the bolts look kind of > threaded which makes me think whoever messed with them last used a > tool...but I have no idea what.


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.