Date:         Thu, 14 Dec 2006 06:33:45 -0800
Reply-To:     Gregory Childs <GAChilds@SDCOE.NET>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Gregory Childs <GAChilds@SDCOE.NET>
Subject:      Re: I'm seeing workshop bench sizes and ideas
Comments: To: David Marshall <mailinglist@FASTFORWARD.CA>
In-Reply-To:  <1829.192.168.0.102.1166067697.squirrel@hasenwerk.homeip.net>
Content-Type: text/plain; charset="us-ascii"

David,

You might try this site for some workshop ideas:
http://www.ronhazelton.com/projects/woodworking_workshops.asp


Greg

************************
Greg in San Diego
'91 Syncro Westfalia Camper (2005-)
'90 Westfalia Multivan (1991-2005)
'78 Champaigne Edition (1978-1991)
'74 Safari Hightop (1974-1978)
'69 Kombi Sportsmobile (1969-1974)

-----Original Message-----
From: Vanagon Mailing List [mailto:vanagon@GERRY.VANAGON.COM] On Behalf Of
David Marshall
Sent: Wednesday, December 13, 2006 7:42 PM
To: vanagon@GERRY.VANAGON.COM
Subject: I'm seeing workshop bench sizes and ideas

I am in the process of doing the drywall and paint in my work shop.
Next I will be building a new work bench.  My original bench was wood
and 24" deep and 36" off the floor and 8' wide - it served my
purposes but now it is time to upgrade to something better.

The
new area for the bench will be 16' wide with four dedicated120V 20A plugs
- my air compressor will go under one section of this bench and some
mobile tool cabinets under another section.  I have a surplus of
2x6" lumber so this will be the frame work of the new bench.  To
top the bench off, I will be using 3/16" thick steel that will be
bent up at the back to catch any spills and bent down at the front for
neatness.  I want to go deeper that 24", but how deep and this
is the question for you people out there who have shop benches.  If
you were to do it again how deep would you go - 32" or 36"
?  I will have a vice on there, drill press and will be doing things
like cylinder head assembly and also fabricating and TIG welding items on
there as well - with the steel bench there will be no need to ground the
work, just make sure it is on the table.  So - please share with me
what you like and dislike about your current setup and stuff that you
would do next time if you got the chance.

Cheers!

David Marshall

http://www.hasenwerk.ca
http://www.fastforward.ca

Box 4153, Quesnel BC, Canada V2J
3J2