Date:         Tue, 19 Dec 2006 09:13:15 -0800
Reply-To:     TC <trclark@SHAW.CA>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         TC <trclark@SHAW.CA>
Subject:      Re: fuel tank sealing
Content-type: text/plain; charset=iso-8859-1

> Sure i  could have replaced both of the "Y"'s and the crossover tube,
> but my tube  was fine, and i took the advice of Kim and took it a step
> further. Behold,  the custom machined replacement part. Fits perfect,
> should work fine.  Cost....nothing.
>
http://pg.photos.yahoo.com/ph/phishman068/album?.dir=4d86re2&.src=ph&store=&
pr
>
odid=&.done=http%3a//pg.photos.yahoo.com/ph/phishman068/my_photos%3furlhint=
ac
> tn,del%253as,1%253af,0
>
> I  figure...thick machined Brass is slightly stronger than 20 year old
> cold  thin plastic right?
so Mr. R. Sisler how come I dont see this in the ebay store come man get on
it :)

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!

Return to the archives @ gerry.vanagon.com

The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.