|
i'm planning on removing the bellhousing, and only media-blasting that, and the parts bob so graciously sent. the rest of the transmission, and the engine, i will be deplaquing with my whizzer (air-powered die-grinder), and a few scotch-brite pads. sudhir p.s. yay for oxford commas.
On 12/25/06, aatransaxle <daryl@aatransaxle.com> wrote: > Sudhir...be carefull about getting sand or grit into the seal areas..Had a > customer go at his trans after a rebuild and I had to take it apart and > clean it afterwards to get the grit out...Daryl of AA Trans > > corridor have a > > media-blaster I would be able to use, borrow, rent or steal? > > I can reimburse you for the media. > > > > I can get most of the transmission case and engine mount with my 3m > > scotch-brite disks, but there are some places on both that the disks > > cannot access. > > > > > |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.