I've just ordered my third Heater Valve in two years. The original one worked for about 6 months, then failed in a way that it would never fully block the flow of hot water. Eventually, the little tab that stops the motion of the lever broke off (probably 'cause I was pushing it too hard in frustration when it began failing to close fully). Replacement #2 worked about 3 months, then developed a leak from the seam -- it drips coolant when the system is under pressure. I'm hoping that #3 will be better. Did I just get unlucky? Or has anyone else noticed a batch of bad heater valves? (part # 171 819 809E) I notice prices on this part are all over the map -- Under $10 at some vendors, up to $20 at others and the dealer. Is there an OEM/ aftermarket difference? If so, what is the "good" brand? |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.