Hi, First thanks to all for the good advice. I had a detailed look at the damage today. As you could see in the photo (link in orig mail) the impact was pretty high up. However, the lower part of the front pillar (where the door hinges are attached) is at least a little bent back. One can see a small comression fold about midway of the pillar (where the upper pillar part is spot welded to the lower pillar), and lifting the carpet, also a little comression behind the driver side step. Pillar behind the driver side door is completely straight though, and I think in total the amount the front pillar is bent back might only be a few mm. It seems to me that a real repair would require a front clip or a 1/4 clip as suggested by many. A "cheap" repair might try to replace just the twisted panel and door, but then the frame would remain a bit twisted. Migth be hard to fit the windshield and new door right. Can a good collisiton shop pull such a distorsion out good enough? Anyhow, in summary the verdict doesn't look so good. Being in a new country it would be a lot ow work to find a both good and reasonably prized body shop to deal with this. I guess I'm likely to pass on this one. Again, thanks for your advice. Martin J
Martin Jagersand wrote: > > > Hi > > > > I'm in Munchen for my sabbatical. Naturally I'm hoping to pick up > > a VW camper to go exploring in Europe. Turns out finding T3's in > > good shape is not so easy here. Most have been used as daily drivers, > > and are worn out inside and out plus rusted out by the road salt. > > > > One of the better ones (ie nice inside, no rust, all new engine, > > tranny, brakes etc) happens to have a collision damage. I'm > > a bit leery of getting into repairs, but seem to have no choice > > (others I have looked at have also needed work). > > > > Please take a look at the damage and say what you think: > > > > www.cs.ualberta.ca/~jag/rec/buss/BesVW_sm.jpg > > > > Is it likely that the frame is twisted? > > > > How does one repair this? Changing panels? > > Or since the front windshield "pillar" took a hit > > hit, is it better to cut out a clip from a junker > > and weld in? > > > > Any other ideas? > > > > Also if someone has any tips of local repairs shops > > here please let me know. (I'm in the western Munich area) > > > > Thanks, > > Martin > > > > |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.