This is very common in old Vanagons.Not much you can do.Nobody will re bore the shaft holes and put a bearing in.Tolerances are just too close. Off by a couple thousands and your butterfly plate will bind. Best to just readjust your throttle switch, and move on to the next problem.Perhaps a weaker return spring will not pull the shaft off center as much.I do not think a new throttle is avaliable,new.At least not for less than $500. |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.