Date:         Thu, 18 Jan 2007 12:32:31 -0500
Reply-To:     Kenneth Wilford <kenwilfy@COMCAST.NET>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Kenneth Wilford <kenwilfy@COMCAST.NET>
Subject:      Re: Window Assembly
Comments: To: BJ Feddish <bfeddish@NETREACH.NET>
In-Reply-To:  <013f01c73b23$5a5989a0$1919a8c0@cspfr>
Content-Type: text/plain; charset="us-ascii"

If I remember correctly you can take the old one out via the slit that the
window normally slides up and down in.  Put the new one in the same way.
You must remove the window glass and rubber around the slit and you should
have enough room to pull the regulator out and put the new one in.

Thanks,
Ken Wilford
John 3:16
http://www.vanagain.com
http://www.strictlyvwauctions.com
http://www.eurovan.org
http://www.vwcabrio.org
Phone: (856)-327-4936
Fax: (856)-327-2242

-----Original Message-----
From: Vanagon Mailing List [mailto:vanagon@gerry.vanagon.com] On Behalf Of
BJ Feddish
Sent: Thursday, January 18, 2007 12:09 PM
To: vanagon@GERRY.VANAGON.COM
Subject: Window Assembly


I need to replace the window assembly in my 83.5 Westy on the drivers side.
I have the door panel off and have no idea how to get it out. It's not
listed in the Bentley manual. Other than hacksawing off half the door, this
one has me perplexed.

Suggestions?

Please CC me, I'm in digest mode.

Thanks,
Bryan