Hi Nathan, That's not quite how it works. Remember that at the same time the heads are being baked to 400F the seats are being chilled to single- digits. The temperature differential uses the expansion of the two metals to ensure a tight fit. But whenever the head heats up to 400F the seats are being heated to the same temp if not hotter (they are closer to the exhaust gases), so nothing gets loose.
Happy Trails, Greg Potts 1973/74/77/79 Westfakia "Bob The Tomato www.pottsfamily.ca
On 24-Jan-07, at 9:19 PM, Nathaniel Poole wrote: > What I was told by a reputable VW rebuilder is that you are > supposed to heat the heads to 400 degrees to press in the new valve > seats; if the engine gets to that temp while running, you are > risking the seats becoming loose through expansion and softening of > the aluminum head. And yet many people talk about running at 450+ > degrees (I have yet to break 350, even on the Coquihalla), and you > mention 550 as a kind of redline. Any machinists out there? Is > there truth to this threshold temperature? |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.