Hi all, just dropped the gas tank and put the reseal kit in, and while there, exchanged the long radiator and heater lines. put it back together again, but really have the following problem: I installed the grommets in the tank, the crossover tube to the chassis, mounted up the tank, then pushed the crossover pipe connectors through the grommets. this was really hard, i was reaching in through the side wheelwell over the frame. I got those two in, but the third one, the overflow from the filler tube, I cannot push in as it is not a t piece and therefore harder to push in at this angle (harder to get a grip.) any trick and tip what to do here? is it easier to put the grommet on the line and then push the grommet in with the line? any tools of help? thanks flo |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.