Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (February 2007, week 2)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Sat, 10 Feb 2007 21:51:24 -0500
Reply-To:     Pascal Giasson <pascal.giasson@GNB.CA>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Pascal Giasson <pascal.giasson@GNB.CA>
Subject:      Re: East coast rust
Comments: To: Karl Mullendore <groups@WESTYVENTURES.COM>

Karl, I see from your picture that you still have some fiberglass insulation in there. I would strongly recommend you replace that with something else that does not hold water. I replaced mine with some aluminized bubble wrap type insulation available at Home Depot. BTW I too use Krown or Rust Check very liberally and it's great stuff to stop the rusties, but you realy need to take the interior out to realy do a good job.

Pascal '84 Westy


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.