Hi Zoltan, The swivwl mechanism is composed of three parts: 1. The base is welded to the fender well between the original seat tracks. This base has a circular track and 4 studs sticking upwards in the center to hold the top plate down. 2. The middle bit sits in the round track and has a set of seat tracks for the seat to fit into. It's open in the middle. You don't slide the seat into the track until the top cover is installed. 3. The top cover plate sandwiches the middle bit in place, and is held down with 4 nylock nuts. Without the bottom swivel base there's no way the seat will be able to rotate properly.
Happy Trails, Greg Potts 1973/74/77/79 Westfakia "Bob The Tomato www.pottsfamily.ca
On 20-Feb-07, at 9:18 PM, Zoltan wrote: > Hi guys, > I was wondering if I can just bolt my removable swivel chair to the > floor if I don't have the tracks. > Archives? > Zoltan |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.