Here is how I remove the tapered shaft of the ball joint. The taper causes the shaft to grip even after the nut is removed.A balljoint fork may tear the rubber boot.That is ok if you dont need to reuse the ball joint. Loosen the big nut a few turns. Then, using a 2 pound hand sledge hammer, hit the cast iorn wher the shaft goes throught the cast iorn. Vibrations wil cause the shaft to release itw grip.Then finish removing the nut. |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.