Date:         Fri, 23 Feb 2007 22:04:45 -0500
Reply-To:     "Peter T. Owsianowski" <pnoceanwesty@GMAIL.COM>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         "Peter T. Owsianowski" <pnoceanwesty@GMAIL.COM>
Subject:      Oil Cooler O Ring Procedure
Content-Type: text/plain; charset=ISO-8859-1; format=flowed

Searched the archives, got 10 pages, been to Ben's Place got that.  got the
Bentley pages marked off.

Seems to be two schools of thought:

1.  Drain coolent and change lines if you are removing the oil cooler to
repair the O ring.

2.  Just pinch off lines, remove oil filter shaft and oil cooler to replace
O ring, then put everything back.

Any opinions?



--
Pete
'79 Westy "Aardvark"
'87 Westy "Joe's Van"
'02 Audi A6 Avant
WWW. Busesbythebeach.com

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!

Return to the archives @ gerry.vanagon.com

The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.