Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (February 2007, week 4)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Mon, 26 Feb 2007 16:41:01 -0800
Reply-To:     Nathaniel Poole <myth.wright@GMAIL.COM>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Nathaniel Poole <myth.wright@GMAIL.COM>
Subject:      Re: alternatives to fiberglass insulation
In-Reply-To:  <23F1582F-3E38-476E-9917-6339A48F426E@comcast.net>
Content-Type: text/plain; charset=ISO-8859-1; format=flowed

I think it is possible to seal the panels. WHen I did my van I used the bubble wrap as a vapour barrier over my insulation, glued the seams with vapour barrier caulk, and then went over all the seams (and many holes) with industrial grade 2" packing tape with a tape gun. I feel confident that in a water crises I could use the interior voids as emergency water tanks. . Also, I did not bother with vapour barrier, way too > > hard > > to do a good job in the westy...too many factory holes > > everywhere...and > > I like the holes and gaps to allow any moisture that does > > inevitably get > > in to get out fast in.

The vapour barrier is on the inside because it will almost always be the warmest and most humid. Not to mention that if the van is in proper shape the exterior walls/windows will be a perfect vapour barrier. > > The vapor barrier is a critical element. Vapor migrates from warm to > cold, so if you stop it from traveling to where the dew point is, > somewhere in your insulation, w/ the vapor barrier, it does not form > at all in your insulation. Now if it is warmer on the outside than > the inside, then the flow reverses direction & you trap it in the > insulation. But generally, vapor barriers are always put on the warm > or inside of the insulation. The best way to do this is like the > current auto mfrs' do, glue a continuous vapor barrier over the > entire wall/ceiling/floor w/ as few holes as possible, & then place > your finish panels over it. A reflective foil works even better than > plastic sheathing, as it reflects radiant heat like mentioned above. > > > > > BTW, nothing beats a good sleeping bag and another warm body to keep > > warm while camping ;o) > > I use a 0-20 degree F bag all year, just opened or spread out > differently depending on air temp, SO next to moi or not. > > > > Tom B.-can you say low emissivity (low E) barrier? >


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.