Hi all. It's warmer outside, the birds are tweeting. Time to get busy, and get dash job completed. On that note.... I want to install a front heater core for future engine conversion to a Wasser. Currently have stock air cooled heater box PN: 251.259.113 It appears (Bentley) that Flap Housing is similar for AC and Wasser. Can a stock Wasser heater core be installed into AC Flap Housing? If so..... Where is best place to drill (if needed) holes for heater core hoses? I'll double check to see if those holes are already there from factory. I imagine I could run heater core hoses down through stock AC heat conduit. Thanks for any help!
-- Neil Nicholson. 1981 Air Cooled Westfalia. |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.