Vanagon EuroVan
Previous (more recent) messageNext (less recent) messagePrevious (more recent) in topicNext (less recent) in topicPrevious (more recent) by same authorNext (less recent) by same authorPrevious page (March 2007, week 2)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:   Thu, 8 Mar 2007 21:31:44 -0800
Reply-To:   Paul Guzyk <paullist@GUZYK.COM>
Sender:   Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:   Paul Guzyk <paullist@GUZYK.COM>
Subject:   Re: Big end rod clearance 2.1 WBX
In-Reply-To:   <33631.96793.qm@web56413.mail.re3.yahoo.com>
Content-Type:   text/plain; charset="us-ascii" ; format="flowed"

You're welcome Tabe.

and don't forget, use lots of lube before you start whacking. (spray WD40 around the wrist pins before using the slide hammer)

>PS Thanks to Paul Guzyk for a post a couple of years ago about using a >piece of 3/8 threaded rod, 3/8" nuts, and a slide hammer to remove the >wrist pins. Worked like a charm! (Did I bend my rods doing that?)


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.