Date: Wed, 14 Mar 2007 11:15:34 -0500
Reply-To: Dennis Haynes <d23haynes57@HOTMAIL.COM>
Sender: Vanagon Mailing List <vanagon@gerry.vanagon.com>
From: Dennis Haynes <d23haynes57@HOTMAIL.COM>
Subject: Re: Caster--was Tire Choice Question
Content-Type: text/plain; format=flowed
If the caster is off, that is one more indication the radius rod bushings
are shot. Don't be surprised at the wear or damage at the sub frame when
they are removed. Actually, I should call them mounts, not bushings. There
is a front/rear piece and a sleeve. The front nut is a locking nut and
probably should be replaced. In rust land, a torch may be needed to get the
rear nut loose. Make sure it can turn for adjustment. The rod may have some
thread damage. They are not too expensive but labor can be. Especially if
you have the cast iron lower control arms as everything will have to come a
part.
Dennis
>From: "Trooz" <trooz@roadrunner.com>
>To: "'Dennis'" <d23haynes57@HOTMAIL.COM>,<vanagon@GERRY.VANAGON.COM>
>Subject: RE: Caster--was Tire Choice Question
>Date: Wed, 14 Mar 2007 08:27:12 -0700
>
>I'm convinced that caster is my problem. Thanks, Dennis. I've been to
>several alignment shops and no one can seem to get it right. Does anyone
>know of a quality alignment shop in southern California?
>
>Bob Trousdale
>'90 Westy
>
> > -----Original Message-----
> > From: Vanagon Mailing List [mailto:vanagon@gerry.vanagon.com]
> > On Behalf Of Dennis
> > Sent: Tuesday, March 13, 2007 5:47 PM
> > To: vanagon@GERRY.VANAGON.COM
> > Subject: Re: Tire Choice Question
> >
> > Personally, the 356's are just lousy tires but they alone
> > should not be scary to drive on. Was the suspension properly
> > inspected for loose/worn components and properly aligned? In
> > particular, the front radius rod bushings need to be checked
> > carefully. The radius rods are the rods that attaché the
> > lower control arms to that front sub-frame. The bushings may
> > look OK but can still be bad. These bushings set the front
> > wheel caster angle. Caster is one of the most important but
> > miss-understood angle of the front suspension. Caster gives
> > the vehicle that "go straight" feeling and returns the
> > steering to center after a turn. Caster angle differences
> > from side to side, (cross caster) is what often causes that
> > sideways pull.
> > The caster is also affected by different size tires
> > front/rear and vehicle loading. A really good alignment guy
> > will also consider tire width when adjusting within the allowed range.
> >
> > Dennis
>
>
|