I didn't remove my axle when I changed my drum brake pads and CV joints, but there is quite a bit of slop in the wheel bearing in the back. I have not inspected the bearings in a long time. I will tighten the rear axle nut per Bentley and see what happens. If it gets worse or better I may have found something. I will check to see if the brake drum is seated also. Thanks, Blake
On 3/20/07, Airic <airic1@comcast.net> wrote: > > did you torque the rear axle nut? > > |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.