> Can anyone please help me identify plug/cable shown in three photos at > this web link? > > Two of the three pins run to an inductive sensor mounted in the engine case near the fly wheel/flex plate. You can see it there where the case flares out to attach to the bell housing, top side, right of center. When hooked up to the appropriate expensive VW dealer device, it gives engine RPM. Kinda the long way to a short end and not very exciting. The third pin connects to nothing. -- John Bange '90 Vanagon - "Geldsauger" |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.