Hi list, Likely this can be found in the archives, but I will hog some bandwidth here anyways: I just had my propane filled with 3 gallons. The tank has the screw type overflow valve on it. The last time it had propane in it might well have been a decade or so ago... I cleaned and prepped the tank and accessories, redid the pipe connections incl teflon tape, then painted the tank and skid plate. Cleaned the tags and labels as good as possible. Now, I think I heard that the tank and system should have been evacuated before filling. This didn't happen, or I doubt it did. When the guy was filling it there was stuff spewing all over the place. All my appliances work fine with the propane now, great actually, but I do have propane smell. I checked all unions and connections and don't see any bubbles. If I open the screw on overfill valve, gas is coming out. Now for the question: Must this overflow valve be opened at filling time? Do I have too much pressure in my tank/system since the air wasn't evacced?? If I turn the valve on the tank off (not the overflow) the gas smell disappears. Should I open the overflow valve until no more gas escapes to even out the pressure? TIA Matthias |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.