Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (April 2007, week 3)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Sat, 21 Apr 2007 03:09:57 -0600
Reply-To:     Martin Jagersand <jag@CS.UALBERTA.CA>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Martin Jagersand <jag@CS.UALBERTA.CA>
Subject:      Re: Jerks/surges when going from coasting to acceleration
Comments: To: Mark Drillock <drillock@earthlink.net>
In-Reply-To:  <46292709.2060906@earthlink.net>
Content-Type: text/plain; charset=ISO-8859-1; format=flowed

Thanks for the tip. Indeed it is an US spec FI engine. I'll try to unplug the throttle switch and see what happens. What does the switch control anyway?

I was also wondering where to lubricate to make the mechanical cabling smoother in general?

Thanks, Martin

On 4/20/07, Mark Drillock <drillock@earthlink.net> wrote: > > Martin, if this is a FI engine you may have a problem with the throttle > switch sticking. You can unplug the connector from the switch harness > and see if it helps. > > Mark > > Martin Jagersand wrote: > > > Hi, > > > > In the '85 Westy I'm getting a bit of surging and > > a jarring ride when going from coasting to acceleration and > > vice versa. > > > > I'm suspecting a combination of loose axial springs in the clutch > > and slightly sticky throttle. It is difficult to step gently > > enough on the pedal to get a smooth engagement of power. > > > > I had a similar problem on a Diesel several years ago and solved > > it by slightly changing the attachment angle of the throttle cable. > > (so more cable pull is required for a particular accelerator motion) > > > > Tried the same here (though cable bracket won't move very much due to > the > > starter), and tried to lubricate the throttle shaft. But I only > > got marginal improvements. > > > > Any other suggestions? (I'm not about to pull the clutch though) > > > > The later diesels have a small gas shock damping the motions > > of the accelerator. Do you think this is a good idea? > > Ideas for jury-rigged substitutions? > > > > Thanks, > > Martin > > -- > > Martin Jagersand > > University of Alberta > > http://www.cs.ualberta.ca/~jag/ > > > >

-- Martin Jagersand University of Alberta http://www.cs.ualberta.ca/~jag/


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.