After the coments recently about cleaning up corroded connectors, yesterday I did. Esp. the shielded not sealed ones that I havn't checked. Some were really bad, tried to clean some and replaced a few connectors. BTW whats a good replacement for better spade connectors, maybe ones that would be more sealed up? The two wire connector for the oil pressure switches was in poor condition, cleaned it up some, but really want to replace. Tonight when driving the pressure light and buzzer came on. Was my oil pressure always low and now that the contacts are cleaner is telling me so or what's up? Should I worry and find a way to test it? If so what would be the easiest way? Thanks
Nate 1990 Flash Silver non GL Orange County, CA |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.