Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (April 2007, week 4)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Fri, 27 Apr 2007 13:02:36 -0700
Reply-To:     Elliot Kane <e_madmax_k25@YAHOO.COM>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Elliot Kane <e_madmax_k25@YAHOO.COM>
Subject:      Re: Cleaning contacts/Oil light buzzer
In-Reply-To:  <342411.290.qm@web51401.mail.re2.yahoo.com>
Content-Type: text/plain; charset=iso-8859-1

After rebuilding my 2.1 I got some bad oil buzzer scares, but after switching to 20w-50 oil and 'sort of' cleaning (I just took it off, rubbed off some of the green stuff, and put it back on a few times) the high pressure oil switch (the one by the water pump) the scares have subsided altogether...not sure if it was the oil or the wiggling of the connections that fixed it though...once the funds are available I'm installing an oil pressure gauge so I know exactly where things are. Seems kinda weird to clean the connections and then get faulty signals, so I would definately look into the problem. Try messing around with the connections a bit--if the problem remains you could try throwing a new sensor or new connections/wires at it, or probably the best option, install a permanent pressure gauge. Not sure how to go about testing the existing stuff though. Hope this helps, Elliot '88 GL Nathan Mc Blain <nmcblain@YAHOO.COM> wrote: After the coments recently about cleaning up corroded connectors, yesterday I did. Esp. the shielded not sealed ones that I havn't checked. Some were really bad, tried to clean some and replaced a few connectors. BTW whats a good replacement for better spade connectors, maybe ones that would be more sealed up?

The two wire connector for the oil pressure switches was in poor condition, cleaned it up some, but really want to replace. Tonight when driving the pressure light and buzzer came on. Was my oil pressure always low and now that the contacts are cleaner is telling me so or what's up? Should I worry and find a way to test it? If so what would be the easiest way?

Thanks

Nate 1990 Flash Silver non GL Orange County, CA

--------------------------------- Ahhh...imagining that irresistible "new car" smell? Check outnew cars at Yahoo! Autos.


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.