Hi David, thanks a lot. Does the thin one has the additional holes (additional to the four 8mm holes in the corner)? If I recall right, at least I think I used this one between cover and pump. And the one with only the holes for the stats between case and pump ... Might be that i am wrong ... Anyway thanks a lot and take it easy. Cheers Thomas David Kao wrote: > --- Thomas Pfrommer <pfrommer@PHAS.UBC.CA> wrote: > > >> Hm do you or anyone know the thickness of these gaskets... >> > > Thomas, I just measured the pair of gasket in my Elring set. The thin one > is about .006" - .007" and the thick one is .02". The thin one was not torn > apart by merely looking at it though. My computer printer paper of 24 lbs > is about .003" - .004" You can make one out a sheet paper of 28 lbs or simply > out a sheet of 24 lbs. > > Well, since I have been considered Not Reasonably Conscious for what I do so > take these numbers at your own risk. I know someone will jump out to cry > bloody murder because I said these. > > David > > __________________________________________________ > Do You Yahoo!? > Tired of spam? Yahoo! Mail has the best spam protection around > http://mail.yahoo.com > |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.