VANAGON archives -- May 2007, week 2 (#134)

Date:         Wed, 9 May 2007 19:09:58 -0400
Reply-To:     Mike Collum <collum@VERIZON.NET>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Mike Collum <collum@VERIZON.NET>
Subject:      Re: tool needed
Comments: To: Jonathan Farrugia <jfarrugi@UMICH.EDU>
In-Reply-To:  <Pine.LNX.4.64.0705091852390.17924@rygar.gpcc.itd.umich.edu>
Content-type: text/plain; charset=ISO-8859-1; format=flowed

Hmmmm .... Next time I have to pull a pilot bearing I might just try
cutting the ears down on a large moly bolt.  It's a thought even though
just lipping the head of a standard bolt behind the bearing then turning
a nut against a washer worked well for me last time.

Mike



Jonathan Farrugia wrote:
> Ken
>
> perhaps something to get your wheels turning.
>
> http://www.boltdepot.com/anchoring-products.aspx
>
> additionally if you have welding an machining capabilities lips could be
> added for a better fit.  or you could roll your own altogether.
>
> jonathan
>

Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!

Return to the archives @ gerry.vanagon.com

The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.