Date:         Fri, 11 May 2007 15:40:48 -0400
Reply-To:     Dennis Haynes <d23haynes57@HOTMAIL.COM>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Dennis Haynes <d23haynes57@HOTMAIL.COM>
Subject:      Re: Head sealants??
Comments: To: Pascal.Giasson@GNB.CA
Content-Type: text/plain; format=flowed

The right stuff must not be used on the cap nuts. The frictional qualities
are not known or suitable for torque critical fasteners. If using the
anaerobic sealant anyway, use that on the cap nuts including the threads.
You should also be using new cap nut. If not, at least chase the threads
with a quality tap. Do not fill the cap nut with sealant or oil as this will
hydraulically lock the nut before it is bottomed and the stud properly
stretched. Coat the nut face and place a small bead on the stud thread.
Final torque should about 37ft/lb. If you feel a stud that is not tightening
or excessively springing back, it needs to be replaced.




>From: "Giasson, Pascal (DNR/MRN)" <Pascal.Giasson@GNB.CA>
>Reply-To: "Giasson, Pascal (DNR/MRN)" <Pascal.Giasson@GNB.CA>
>To: vanagon@GERRY.VANAGON.COM
>Subject: Re: Head sealants??
>Date: Fri, 11 May 2007 15:58:59 -0300
>
>I guess I was not clear with my last post...not the first time...and
>likely not the last...sorry folks
>
>I have the Right Stuff for the heads and for under the cap nuts.  I have
>the Permatex Anaerobic Gasket maker #51813 for the push rod tub seals
>and the lower black O-ring on the cylinder.  My question is: the
>instruction on the 51813 says to use a special primer (which I bought)
>and then apply the 51813.  The primer is in an aerosol and it would be
>very challenging to use it without getting it everywhere, which would
>not be good.  What do people do?  Can the 51813 be used with out the
>primer?
>
>Thanks
>
>Pascal
>
>
>-----Original Message-----
>From: Vanagon Mailing List [mailto:vanagon@gerry.vanagon.com] On Behalf
>Of Ben
>Sent: May 11, 2007 3:22 PM
>To: vanagon@GERRY.VANAGON.COM
>Subject: Re: Head sealants??
>
>NO 518 on HEADS!!!! ??? You need "The Right Stuff" on heads Gasket, 518
>is good elswere (i like to put some on the lower blacl O-RIng BUT
>NOWHERE on head gasket!!!
>Ben