Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (May 2007, week 2)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Sun, 13 May 2007 16:04:28 -0700
Reply-To:     Mark Keller <kelphoto@TELUS.NET>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Mark Keller <kelphoto@TELUS.NET>
Subject:      2.1 new sensor and still no cold idle...
Comments: To: zolo@FOXINTERNET.NET
Content-Type: text/plain; charset=ISO-8859-1; format=flowed

Zoltan, is this a Temp II sensor? Cold idle is also a iffy one, while is true the iSV is the device, It can't really offset a bad Temp II. And just to say so, I recently purchase a Temp to that worked perfectly , but was about 30 ohms off and gave me a overly rich cold start.

I found this by dunking several I have in hot and cold water and timing the the change to stable and noting final begin and ending values.

Mark


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.