Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (May 2007, week 3)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:   Thu, 17 May 2007 13:03:45 -0700
Reply-To:   TC <trclark@SHAW.CA>
Sender:   Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:   TC <trclark@SHAW.CA>
Subject:   Re: Fresh Water Tank Drain Cap - Non VW replacement source?
Content-type:   text/plain; charset=iso-8859-1

> Best thing to do is measure the outside diameter of the drain outlet to > determine which cap it is. The larger earlier one is 34mm I believe. hmm i have an 85 the dia from the ide thread to thread is 30mm the inside dia of the cap (where the hole is) is 35mm ouside dia edge to edge 40mm

I think the best option has got to be to get some large die 1.25" say that is sae thread & chase those threads down

hee a dis for 1 use on plastic cant be more than $5 and as you say 98 cent cap

any one done that with what exact die & what cap did you then get


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.