I'm trying to install a pass. swivel seat unit I purchased years ago on-line and have ?'s. The unit I purchased supposedly came from a full camper Westy, it's the entire swivel unit - both the base and the seat tracks. The swivel base is integral to both these parts: a round grove between the two parts. You push down on a small level (goes in a front factory grove just for this) to make seat swivel. If I place unit atop my existing passenger seat tracks, that's redundant (2 seat tracks) and puts seats 1 inch too high I'm afraid. Do I cut out my existing tracks so that I end up w/ only one; if so, that's hard to accomplish! Is there an easier way to install this unit? I'll take a photo next time and email such to the group? Larry Ga.
--------------------------------- Finding fabulous fares is fun. Let Yahoo! FareChase search your favorite travel sites to find flight and hotel bargains. |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.