Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (May 2007, week 4)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Fri, 25 May 2007 21:24:08 -0400
Reply-To:     Dennis Haynes <d23haynes57@HOTMAIL.COM>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
Comments:     RFC822 error: <W> MESSAGE-ID field duplicated. Last occurrence
              was retained.
From:         Dennis Haynes <d23haynes57@HOTMAIL.COM>
Subject:      Re: How much life in a Factory Rebuild
Comments: To: C B <cunegonde.van.westfalia@GMAIL.COM>
In-Reply-To:  <176e7f500705251216q6fd4f885vdd9fd5d50c19b50a@mail.gmail.com>
Content-Type: text/plain; charset="US-ASCII"

Generally speaking, if a rebuilt engine has a defect, it shows up immediately or in the fist few hundred miles. Poorly machined valve seats and some other issues may show up long after. Almost all other engine failures are the result of outside influences. These can be anything from cooling or lube system failures to improper engine settings or outright driver abuse.

Since you had recent water pump failure, a perfectly good engine regardless of mileage has suffered a trauma and can be immediately damaged. If the coolant was lost while the engine was hot and under load, damage is done even if shut down immediately. The sudden loss of coolant pressure and steam expansion alone can cause warpage and gasket damage. Once those 400 degree heads were no longer filled with coolant, guess what.

Dennis

-----Original Message----- From: Vanagon Mailing List [mailto:vanagon@gerry.vanagon.com] On Behalf Of C B Sent: Friday, May 25, 2007 3:17 PM To: vanagon@GERRY.VANAGON.COM Subject: How much life in a Factory Rebuild

I rested from my waterpump-changing labors by reading the frightening tale of Cunegonde's receipts dating back to 1991 (she's an 83.5 1.9l WBX)

She's had a lot of owners, and the receipts tell me why.

Among other incidents, in 1998, with about 165k on the engine then in the van, a Seattle VW dealership installed a VW factory-rebuilt engine. Probably a 2.1, although she still has digijet EC as far as I can tell. Judging from the receipts, it ran poorly. By 2003, with less than 30k miles on that rebuilt engine, it had gone through *three* cylnder heads. That engine now has about 40k on it.

3 cylinder heads in 30k? Do I contact VW? That's outrageously bad quality, considering VW rebuilt it, and I have all the receipts for installation, maintainance, oil changes, and so on. What can I do to keep her going? An engine change, even if I do it myself, is not currently in my budget.

Ugh, now on to figuring out why I have no reverse, 3rd, or 4th gear.

-- Bretts

1983 1.9l WBX Ivory Westfalia "Cunegonde"


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.