--- "Giasson, Pascal (DNR/MRN)" <Pascal.Giasson@GNB.CA> wrote: > Well, I got my 2.1 that was converted to fit in my 84. Not exactly what I expected... I have a > question about the cylynder heads, one is p/n 025 101 375, the other is p/n 025 101 375c. My > old '84 cylinder heads are p/n 025 101 375. So I'm assuming that the PO put a 1.9 cylinder head > on the 2.1 motor I just bought. Does any one know if the p/n 025 101 375c cylinder head is from > a 2.1. I checked with ETKA but those numbers dont match up. I know it's not good to mix 1.9 > and 2.1 heads on the same motor. Thanks > Pascal > '84 Westy > My understanding about the two is that if 1.9 cylinder heads are put on a 2.1 engine they will give you a slightly higher compression ratio. It is not too desired if it is the other way around. So either you have got a correct pair of heads or you have got a slightly higher compression ratio. David
____________________________________________________________________________________Sick sense of humor? Visit Yahoo! TV's Comedy with an Edge to see what's on, when. http://tv.yahoo.com/collections/222 |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.