Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (May 2007, week 5)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Thu, 31 May 2007 19:57:27 -0300
Reply-To:     "Giasson, Pascal (DNR/MRN)" <Pascal.Giasson@GNB.CA>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         "Giasson, Pascal (DNR/MRN)" <Pascal.Giasson@GNB.CA>
Subject:      cylinder head advice
Content-Type: text/plain; charset="iso-8859-1"

Well, I got my 2.1 that was converted to fit in my 84. Not exactly what I expected... I have a question about the cylynder heads, one is p/n 025 101 375, the other is p/n 025 101 375c. My old '84 cylinder heads are p/n 025 101 375. So I'm assuming that the PO put a 1.9 cylinder head on the 2.1 motor I just bought. Does any one know if the p/n 025 101 375c cylinder head is from a 2.1. I checked with ETKA but those numbers dont match up. I know it's not good to mix 1.9 and 2.1 heads on the same motor. Thanks Pascal '84 Westy


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.