Quoting Mike Collum <collum@VERIZON.NET>: > The stock north American grilles used 1/4 turn screws whereas the SA > grilles use studs or attached pins that push into those old > receptacles. > I've read where some have had to pry to remove the SA grille and are > concerned about breaking it. > > I found that I could insert a screwdriver shaft between upper and > lower > parts of those receptacles and gently pry them apart to the point > where > they securely hold the grille but prying the grille off isn't > necessary. > Mine now pulls off with just the right amount of resistance.
If I remember rightly, the two (or was it one?) fittings between the outer pins can be exchanged for the German turn-fittings. |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.