Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (June 2007, week 1)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Fri, 1 Jun 2007 13:13:25 -0400
Reply-To:     chris Moyles <chris@FAUQUIERHOUSING.ORG>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         chris Moyles <chris@FAUQUIERHOUSING.ORG>
Subject:      Re: Exhaust manifold blown - rusted bolts...tips?
Comments: To: Marla Stelk <mjstelk@HOTMAIL.COM>
In-Reply-To:  <BAY131-F14F55DCAB70DFBEFA76E43AD2C0@phx.gbl>
Content-Type: text/plain; charset=ISO-8859-1; format=flowed

I just went through this process and had to grind off the bolt heads-

FYI - I ordered a set of exhaust manifolds one of our list venders: it came from S & S headers in three pieces - The front manifold was one piece and the rear was two pieces with slip fittings... 4 hours and a lot of swearing later I got the thing on and together and it is just enough out of alignment that I've got a leak at the front left of the manifold port. Be warned, if you get one of these you might have to take it to be heated and bent to fit properly. Also, there was not enough clearance for the rock shield/bottom engine mount to bolt properly back to the bottom of the engine.

On top of that, now the van has an idling issue. After it warms up for about 5 minutes it doesn't idle - So I day of troubleshooting ahead, could be anything from a clogged catalytic converter (already checked the O2 sensor), etc...

Funny thing, the van was running like a champ before I decided to fix the exhaust leak...

Such is life - and get a quality replacement part!

chris

Marla Stelk wrote: > Hello listees, > > So I foolishly thought it would be a simple fix... > I have a leak in my exhaust where a manifold has either deteriorated > or blown out (the cause I'm thinking of my idling issues). I bought a > new one to replace it thinking I could just undue the exhaust bolts, > slide the old one out and slide the new one in. Of course, however, > my exhaust, although replaced about 4 years ago is all rusty now and > the bolts are basically parts of the pipes now. Any tips on how I > should proceed? > > Thanks in advance, > MJ Stelk > '87 Westy GL > > ------------------------------------------------------------------------ > Get a preview of Live Earth, the hottest event this summer - only on > MSN <http://g.msn.com/8HMAENUS/2743??PS=47575>


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.