Good folks, I'm wiring a 4-wire O2 sensor from my Saab 9K into the '84 Vanagon, since it's the same part number as the sensors for the '91 and should therefore put out the right signal. Looking at the Bentley 97.72 it appears that the heating element hot wire is to terminal 86 of the fuel pump relay but I'm a bit confused by the diagram. Can anyone tell me if this is correct ('86 and up?) I don't want to overload any ciruits by adding this in. thanks
Geza
BTW the V already runs better with the new/used sensor, even without the heating element hooked up... |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.