Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (July 2007, week 1)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Mon, 2 Jul 2007 09:49:08 -0700
Reply-To:     Tom Sinclair <neeemo@YAHOO.COM>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Tom Sinclair <neeemo@YAHOO.COM>
Subject:      Re: EGT Gauge Question (cross post)
Comments: To: David Etter <detter@MAIL.AURACOM.COM>
In-Reply-To:  <f06240802c2aea0f4d8b4@[192.168.1.100]>
Content-Type: text/plain; charset=iso-8859-1

They make them to 75 feet. I buy my 25 footers there: http://www.egauges.com/vdo_send.asp?Sender=ISSPRO_Pyrometer_Lead

Tom

--- David Etter <detter@MAIL.AURACOM.COM> wrote:

> This is an attempt to tap into a wider list > knowledge outside the > 'Diesel Vanagon' forum.... > > Question: > Is there anyone out there who has installed > an EGT gauge who > has concerns about the accuracy of the gauge. > > I ask this because I was reading on one > man's blog about his > installation of an EGT Gauge...Quote.."The leadwire > from the > thermocouple (it's a special wire, don't cut it to > lengthen or > shorten and don't solder the connections)" > Unquote... > > I had excellent feedback (from Diesel-Vanagon) on > why not to > cut/extend/solder/screw up the supplied wire > harness, but no clear > solution to the problem. I can't believe that of all > the people who > have installed these pyrometers that each and every > one, did the > 'correct' thing and purchased 'special' wire or > calibrated the gauge. > > Perhaps someone on the list has a source for this > wire. I bought the > 'kit' from "eGauges" > http://www.egauges.com/vdo_mult.asp?Type=Pyrometer&Series=Vision > and they don't list longer wire of any length. (24' > wanted). > > Unless I can find the 'proper' wire, I think > I will have to > set up a bench test and actually 'calibrate' the > gauge using a stable > heat source set to accurately pinpoint 1000 degrees > and use that as > an installed reference point. > > David (dsl82westy) >

____________________________________________________________________________________Ready for the edge of your seat? Check out tonight's top picks on Yahoo! TV. http://tv.yahoo.com/


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.