Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (July 2007, week 2)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Mon, 9 Jul 2007 16:11:43 -0300
Reply-To:     "Giasson, Pascal (DNR/MRN)" <Pascal.Giasson@GNB.CA>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         "Giasson, Pascal (DNR/MRN)" <Pascal.Giasson@GNB.CA>
Subject:      tip on taking dents out of pushrod tubes
Content-Type: text/plain; charset="us-ascii"

I managed to take some minor and major dents out of some pushrod tubes by using a Gray brand 14mm socket and tapping it through the tubes. When I got to a dimple I would lightly tap on the dimple from the outside with a hammer and it would completely remove the dimple. It worked amazingly well even on some tubes that looked like they were beyond repair.

Pascal

'84 Westy


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.